Wolf Tooth Locked-In Bar Ends give riders ultimate control and reduced fatigue during high speed technical riding and racing. This design is a collaboration with World Cup downhill athlete Joe Breeden.

• Allows the rider to use the sides of their hands to push against the ends of the bars for increased control and reduced fatigue
  
• A firm ergonomic rubber outboard flange supports and locks in the riders hand allowing for a lighter grip on the bars and reduced arm pump
  
• Protects the hand/pinky finger
  
• Patent Pending

Compatibility

• Compatible with most carbon and aluminum handlebars with an 18.0mm or wider internal diameter.
• Use of the Locked-In Bar Ends requires a grip with an open end. Many grips with closed ends can still be made to work by punching out the closed end. We sell a punch for this here.
  
• Some grips may have a removable bar end but still have a small lip on the plastic liner that keeps the grip from being able to be pushed inboard from the end of the bar [Ergon GA2, GDH]. We recommend removing this lip by sanding it off using a Dremel tool.
  
• What grips don't work:
  
  • Grips with angled ends [Ergon GE1 Evo]
    
  • We don’t suggest using grips with outboard lock on clamps, especially if the outboard clamp is an integrated bar end [Chromag Squarewave]

Incompatibility Note:

• Deity Speedway Carbon: Internal step; may fit if the bars have not been cut down.
  
• Chromag BZA Carbon: Internal step; may fit if the bars have not been cut down.
  
• Hope 35R Carbon: Not compatible (internal diameter is too small).
  
• Wolf Tooth has not tested every handlebar on the market, so there may be other incompatible models. If you find a handlebar that does not fit, please contact Wolf Tooth customer service